How to Maintain Pneumatic Pump

May 29, 2024 Leave a message

Clean Components

Cleaning with cotton waste or other cloths that have lint is not recommended for the components of the pneumatic pump system. Also, remember to plug the hose ends when changing a cylinder to keep the impurities out. And when you clean the pneumatic cylinders, you must check out for the blind end and piston rods with links. Additionally, your components and actuators of the pneumatic pump system must be cleaned every four weeks.

 

Replace Components

The replacement of components depends on the recommended schedule of your pneumatic pump system's manufacturer. For most systems, their air filter must be replaced every six months. On the other hand, pneumatic air mufflers or silencers must be replaced or cleaned as needed.

 

Lubricate the Seal

One component of a pneumatic pump system that wears off easily is its seal. A seal can be damaged prematurely due to insufficient lubrication, improper installation, defective slide surface, and impurities. If you decide to replace your valve or cylinder seals, then make sure that you lubricate them and their slide surfaces with silicon or paraffin grease. Refrain from using Molykote-type grease as it contains hard particles that can cause your seals to wear out. It is also important that you do not apply too much lubricant since too thick a layer can prevent your seals from functioning properly.

 

Prevent Air Leaks

Any compressed air leaks on your components can lead to improper operation of the whole pneumatic pump system. To mitigate any leaks, you can use gaskets or an appropriate Loctite compound. When you opt to use an adhesive compound, you must make sure that the circuit is depressurised until the compound has fully cured.